A bang like a gunshot from the garage, and now the door won’t move: that is usually a broken spring. The safe way to handle garage door spring repair is not to do the repair yourself. You make the garage safe, then you call somebody trained.
The short answer: The safe way to handle a broken garage door spring is to stop using the door, keep people and cars out from under it, leave the red release cord alone if the door is open at all, and have a trained technician replace the spring. Springs, cables and bottom brackets hold enough tension to lift the whole door, and that tension is what hurts people. Your part is to look without touching, spot the signs early, and know what a proper spring job looks like.
I’m not saying this to sell you a repair. I’m saying it because the spring is the one part of your garage door that hits back. Plenty of jobs on that door I’ll happily teach you. This one I won’t.
Mo
I’ve watched the videos. Some fella in flip-flops, two pieces of rebar from the shed, and twelve minutes later he’s telling you how much he saved. Nobody posts the video where the bar slipped.
You don’t have to fix a spring to be smart about springs. Know what they do, know the signs, know what to do in the first ten minutes after one lets go, and know what good work looks like. That part is all yours.
What garage door springs do
Your opener doesn’t lift your garage door. The springs do. The door is the biggest moving thing on most houses, and the springs are its counterweight, wound up in steel. As the door comes down, they load up. As it goes up, they hand that energy back and carry the weight. Take the spring away and what’s left is the full dead weight of the door. The opener wasn’t built for that. Neither was your back.
Torsion spring vs extension spring
There are two kinds. Stand inside with the door closed, look up, and you’ll know which one you have.
| Torsion spring | Extension spring | |
|---|---|---|
| Where it sits | On a steel shaft above the door | Beside the horizontal tracks, one on each side |
| How it works | It twists | It stretches |
| If it breaks | The shaft holds the broken spring in place | It needs a safety cable through its center to hold the pieces |
| How long it lasts | Generally longer | Generally shorter |
| Where you see it | Newer, heavier or wider doors | Older homes and lighter doors |
Got extension springs? Look for a cable running through the middle of each one. DASMA, the door manufacturers’ association, says in its safety tips that every extension spring needs that cable to keep a broken spring contained. No cable? Have the door looked at.
Signs of a broken garage door spring
A spring that has let go usually announces itself:
- A loud bang from the garage.
- A gap in the coils. A torsion spring that was one long coil is now two pieces.
- An extension spring hanging loose or stretched out of shape.
- A door that won’t lift, or is suddenly far too heavy to lift by hand.
- An opener that strains, or raises the door a little and quits.
- A door that hangs crooked, or a cable gone slack. See how I diagnose a crooked door.
A spring that’s wearing out is quieter about it. The door feels heavier than it used to, the opener works harder, and there’s rust on the coils.
Here’s the one test I’ll hand you, and only when the springs are in one piece. With the door fully closed, pull the red release cord. If the door moves on its own, stop. If not, lift it three to four feet off the floor and ease your hands away. A balanced door stays put. If it drops or feels heavy, lower it, reconnect the opener and call. The Consumer Product Safety Commission warns that a badly unbalanced door can crash to the floor.
How long do garage door springs last?
Springs aren’t rated in years. They’re rated in cycles, and one cycle is one trip up and one trip down. A door maker’s guide I checked puts standard residential springs at around 10,000 cycles, and calls that roughly six to seven years depending on use. If the garage is your front door, the count runs up faster. Rust shortens it either way.
Your garage door spring broke: the first ten minutes
Here’s the whole list. It’s short on purpose.
- Stop using the door. No wall button, no remote, no “one more try.” DASMA’s inspection checklist says it plainly: if a spring is broken, do not operate the door until the spring is replaced.
- Keep people, pets and cars clear. Nobody walks or parks under a door that’s open or partly open.
- If the door is open or partly open, leave the red release cord alone. The opener may be the only thing holding that door up. With a broken spring, a released door can fall fast.
- Look. Don’t touch. From a few steps back you can see a gap in a spring or a cable hanging loose. Hands off the springs, the cables and the brackets at the bottom corners.
- Call. We answer the phone 24/7.
And here’s what is not safe:
- Lifting the door by hand “just to get the car out.” That’s the full weight with nothing helping you.
- Running the opener to force it.
- Propping a half-open door on a ladder or a board.
- Loosening any bolt, screw or bracket near a spring or a cable.
Car stuck inside? Call anyway. A trained tech can get that door open safely.
Why garage door spring repair injures people
Three things do the damage.
- Stored tension. A spring is loaded the most when the door is closed and everything looks calm. When a part comes loose, that energy goes somewhere.
- Winding bars. A torsion spring is tightened and released by hand with steel bars. If a bar slips, doesn’t fit, or isn’t a winding bar at all, the spring takes it out of the hand that’s holding it. DASMA’s data sheet on spring life calls too much torque, or winding a spring backwards, a safety issue even for the installer.
- Cables and bottom brackets. The lift cables tie the springs to brackets at the bottom corners of the door, so they carry the same load. DASMA says only a trained technician should adjust or loosen those brackets.
How to replace a garage door spring: what a proper job looks like
You’re not going to do it. You’re going to hire it. So here’s what a proper garage door spring replacement looks like, so you can tell good work from a quick buck.
- A quote before work starts. Itemized, so you know what it costs before a wrench comes out.
- Both springs, if the door has two. DASMA’s safety tips say to replace both, even if one is not broken.
- Springs matched to your door’s weight. Not whatever’s on the truck. DASMA says the wrong spring wears out the door and the opener sooner and can make the door unsafe to work by hand.
- Everything attached gets checked. Cables, drums, bearings, bottom brackets, and the safety cables on extension springs.
- The door gets balanced. Disconnected from the opener, it should lift easily, stay put halfway and stay up when it’s fully open.
- The safety reversal gets tested. A 2×4 goes flat on the floor under the door. The door should touch it and go back up.
If somebody swaps one spring and skips the balance check, you got a part. You didn’t get a repair. That list is how my crew handles every garage door spring repair.
How to make springs last in Florida’s salt air and humidity
Springs die of two things: use and rust. Rust is the one you can fight. DASMA’s data sheet on spring life says rust thins the spring wire and weakens it, and that rust pits are where cracks get their start.
- Keep the door closed. The same sheet says doors near salt water should stay closed where possible. An open door lets heat, moisture and salt air at the springs.
- Keep the coils from going dry. DASMA says lubricating springs the way the door maker’s instructions call for helps them last. My crew does it on every tune-up. The homeowner version is in my maintenance guide.
- Mind the pool chemicals. DASMA says acids containing chlorine can corrode springs. Keep the jugs sealed and stored away from the door.
- Don’t add weight without a rebalance. If you insulate the door, have the balance checked afterward.
- Look monthly, tune up yearly. That’s DASMA’s schedule, and the yearly maintenance visit is when a tired spring gets caught before it breaks.
Mo’s Notebook: when to stop and call
- You heard a bang, and the door won’t lift or is suddenly heavy.
- There’s a gap in a spring, or a spring or cable is hanging loose.
- The door is crooked, or stuck open or partway.
- The door fails the balance test. It drops, creeps or shoots up.
- Somebody in the house is watching a spring video and eyeing the toolbox.
Garage door spring repair help across Florida
Broken garage door spring? That’s a spring repair call, and my crew runs them every day from Naples, Cape Coral and Port Charlotte to Stuart and West Palm Beach. See every area we cover. Not sure it’s the spring? See the nine most common garage door problems, or book a garage door repair visit.
Have Mo Better replace that spring
Garage door spring repair: FAQ
Can you open a garage door with a broken spring?
You shouldn’t. With a broken spring you’re lifting the full weight of the door, and neither you nor the opener is built for that. DASMA’s guidance is not to operate the door until the spring is replaced.
How do you replace a garage door spring?
A trained technician releases what tension is left, fits new springs sized to the door’s weight, then balances the door and tests the safety reversal. I won’t walk you through doing it yourself, because the winding is exactly where people get hurt.
How long do garage door springs last?
Springs are rated in cycles, and one cycle is the door going up and coming down once. A door maker’s guide I checked puts standard residential springs at around 10,000 cycles, or roughly six to seven years depending on use.
What are the signs of a broken garage door spring?
The usual signs are a loud bang from the garage, a visible gap in the spring’s coils, and a door that won’t lift or is suddenly very heavy. If you see any of them, stop using the door.
My garage door spring broke while the door was open. What do I do?
Leave it where it is and keep everyone out from under it. Don’t pull the red release cord, because the opener may be the only thing holding the door up. Keep hands off the button and call for a repair.
What is the difference between a torsion spring and an extension spring?
A torsion spring sits on a shaft above the door and twists. An extension spring runs beside the horizontal track on each side and stretches. Torsion springs generally last longer, and extension springs need a safety cable through the middle.
Should both garage door springs be replaced at the same time?
Yes, if the door has two. They were installed together and have done the same work, so the second one isn’t far behind. DASMA’s safety tips say to replace both even if one is not broken.
Have a technician replace the spring
A spring is a small part doing the biggest job on the door. Watch it, and when it breaks, keep your hands off and let somebody trained make it safe. Call Mo Better, and we’ll come over and make it right.
